|September 30, 2009, 08:52||
Straight fin of uniform cross section
Join Date: Sep 2009
Posts: 4Rep Power: 9
hello to everybody. I have a fin ( straight fin of uniform rectangular cross section: w*t*l; w,l>>t)) attached to a three-dimensional brick (H*T*W). To the purpose to enhancing the volume mesh, could i simplify the fin with a two dimensional fin ,deleting the thickness t and modeling the conduction along l and w? in this case, the interface among the fin and the solit would be an edge (lenght =w), can the conduction heat transfer happen anyway?
Last edited by Agovale46; September 30, 2009 at 09:24.
|Thread||Thread Starter||Forum||Replies||Last Post|
|cross section visualization||Nelly||FLUENT||3||January 24, 2007 08:51|
|cross section average||Paul||FLUENT||0||April 12, 2006 11:30|
|Cross section and surface area factor||Fabiana||CFX||0||January 10, 2006 00:51|
|Cross section 3d mesh||nic||CFX||4||March 14, 2004 06:59|
|mass flow rate at different cross section !!||Nyquist||CD-adapco||7||September 15, 2003 12:13|