 |
 |
 |
|
|
|
[Sponsors] | ||||
December 1, 2009, 07:52
|
Hollow Cone Injection Problem
|
#1 |
|
New Member
Jakub Broukal
Join Date: Dec 2009
Posts: 13
Rep Power: 16  |
Hi,
I am using Fluent 6.3.26 to model a hollow cone spray. Fluent offers "solid cone" injection and "cone" injection. I hope I get it right when I suppose that in this terminology "cone" = "hollow cone"...please correct me if I am wrong. The problem is that when I display the particle tracks of my (hollow) cone injection, there is a lot of particles "inside" the cone. First I thougth it's due to the droplet collision and breakup models, but the problem persists even after disabling all physical models and/or interaction with continuous phase. Am I missing something here? Any help is appreciated. Regards, Jakub B. Last edited by JaC; December 3, 2009 at 03:02. |
|
|
|
|
|
December 3, 2009, 03:03
|
|
#2 |
|
New Member
Jakub Broukal
Join Date: Dec 2009
Posts: 13
Rep Power: 16 |
Anybody encountred a similar problem? Any tips?
|
|
|
|
|
|
 |
| Tags |
| cone, dpm, hollow, injection, particle tracking |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DPM mass problem | Henrik Ström | FLUENT | 9 | May 20, 2016 11:00 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| problem in solving "wave generation" problem | san | FLUENT | 2 | April 3, 2006 23:37 |
| The problem with GAMBIT - using two mesh sizes. | Owen | FLUENT | 2 | June 22, 2005 05:16 |
| problem with using colocated code | Jack | Main CFD Forum | 0 | December 15, 2002 00:15 |
Linear Mode
