CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Using a boundary profile file with unsteady, spatially varying data

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   December 8, 2009, 16:49
Post Using a boundary profile file with unsteady, spatially varying data
  #1
New Member
 
Jonathan
Join Date: Dec 2009
Posts: 2
Rep Power: 0
jonnythewlis is on a distinguished road
Hi, I was wondering if anyone can help me, I'm trying to use a boundary profile file to set a velocity inlet boundary condition where the velocity in the x direction varies with position on the inlet surface and also with time, therefore there are 5 variables that I need to put into the boundary profile file, x,y and z coords, time, and x-velocity.

I have tried putting these in a file of type 'point', but it doesn't seem to recognise the variables for what they are. I found on one of the threads on here that you can use a type 'transient' file to create an unsteady, time varying profile, and managed to run an unsteady case successfully without spatial variation of the velocity, but when I change the velocity with spatial coordinate aswell as time variation it doesn't seem to recognise it. Does anyone know what I'm missing?

Thanks a lot
Jonny
jonnythewlis is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 60 July 17, 2024 06:45
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found piprus OpenFOAM Installation 22 February 25, 2010 14:43
CFXSolver Error Message using Profile Data on B Tobias CFX 0 August 26, 2005 08:27
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues michele OpenFOAM Meshing & Mesh Conversion 2 July 15, 2005 05:15
error while compiling the USER Sub routine CFD user CFX 3 November 25, 2002 16:16


All times are GMT -4. The time now is 08:42.