 |
 |
 |
|
|
|
[Sponsors] | ||||
January 26, 2010, 03:30
|
Creating surfaces with cooper cross sections
|
#1 |
|
New Member
Esinti
Join Date: Jul 2009
Posts: 10
Rep Power: 18  |
I want to create surfaces for post processing from some of cooper mesh cross sections of default interior. Vectors of all cooper mesh cross sections surfaces are viewed when select default-interior. However, I want to select a few of them.
Thanks. Esinticik |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
| creating surfaces from lot of xyz data | rolando guerrieri | Fidelity CFD | 3 | February 26, 2016 14:43 |
| Importing or Creating 2D Flat Surfaces into CFX | Sam | CFX | 5 | March 30, 2013 12:11 |
| creating new surfaces | fluentguy | FLUENT | 1 | May 7, 2009 04:34 |
| Pressure drop between cross sections | Mauro | Main CFD Forum | 0 | September 13, 2007 03:09 |
Linear Mode
