|February 6, 2010, 04:00||
Philip Mprezas ( firstname.lastname@example.org )
Join Date: Jan 2010
Location: Athens, Greece
Posts: 13Rep Power: 9
Hello from Greece.
I am modeling a PEM fuel cell as the tutorial of fluent
I am facing a problem of step 7 of tutorial.
Comparing the results is the same except the current collectors.
Trying to I find what happend I found the difference between mine case and ansys case on boundary conditions - uds which my case does not have the water content and saturation. Check the picture below, at the right hand is ansys case at the left is mine.
Could you tell me what happend and how can I add the water content and saturation to UDS?
Thank you very much.
Thank you again..
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDS problem with wall boundary condition||Alex F.||FLUENT||15||September 21, 2015 09:28|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|problem in solving "wave generation" problem||san||FLUENT||2||April 3, 2006 23:37|
|Is this problem well posed?||Thomas P. Abraham||Main CFD Forum||5||September 8, 1999 14:52|