|
[Sponsors] |
Exporting Fluent boundary conditions for Ansys FEA |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 22, 2010, 12:14 |
Exporting Fluent boundary conditions for Ansys FEA
|
#1 |
New Member
Join Date: Aug 2009
Posts: 3
Rep Power: 17 |
I'm performing an analysis in Fluent where the resulting pressures on a surface are intended to be input to ANSYS for a stress analysis.
I'm not sure how this should be done though and would very much appreciate any help. We don't have Workbench which I know is designed for this kind of simulation, just Fluent and ANSYS. The mesh structure in each model will also be different, will this cause any problems? Thanks a lot. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 06:05 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Exporting Boundary Conditions | Andrew | FLUENT | 2 | November 23, 2004 18:17 |
Periodic boundary conditions in parallel fluent 6 | Newuser | FLUENT | 0 | May 7, 2003 10:26 |
Boundary Conditions | Jan Ramboer | Main CFD Forum | 11 | August 16, 1999 09:59 |