problem with FFT in fluent 12

galapago · April 8, 2010, 18:24

i´m working in a typical fluid around cylinder simulation. i put 3 velocity monitors, run the simulation and then i try to make a fft plot, but show an error "Process_and_Plot: Negative time-step! do-plot: No data points in range.". i dont know why this happened.

another problem, when i click in LOAD INPUT FILE the file where it's supossed that the monitors are, is empty. then i clik in FILES OF TYPE and then ALL FILES, only in this way the monitors appear.
can somebody help me?
thaks a lot in advance

Maxmum · June 4, 2010, 17:52

Quote:

Originally Posted by galapago

i´m working in a typical fluid around cylinder simulation. i put 3 velocity monitors, run the simulation and then i try to make a fft plot, but show an error "Process_and_Plot: Negative time-step! do-plot: No data points in range.". i dont know why this happened.

another problem, when i click in LOAD INPUT FILE the file where it's supossed that the monitors are, is empty. then i clik in FILES OF TYPE and then ALL FILES, only in this way the monitors appear.
can somebody help me?
thaks a lot in advance

i confront the first problem too

April 8, 2010, 18:24	problem with FFT in fluent 12	#1
galapago New Member omar Join Date: Apr 2010 Posts: 23 Rep Power: 9	i´m working in a typical fluid around cylinder simulation. i put 3 velocity monitors, run the simulation and then i try to make a fft plot, but show an error "Process_and_Plot: Negative time-step! do-plot: No data points in range.". i dont know why this happened. another problem, when i click in LOAD INPUT FILE the file where it's supossed that the monitors are, is empty. then i clik in FILES OF TYPE and then ALL FILES, only in this way the monitors appear. can somebody help me? thaks a lot in advance

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem running Fluent on amd64	Manfred	FLUENT	10	March 23, 2013 07:47
Problem in IMPORT of ICEM input file in FLUENT	csvirume	FLUENT	2	September 9, 2009 01:08
Fluent boundary conditions problem	bobo	FLUENT	2	July 3, 2009 06:28
Fluent parallel license problem	brothershuai	Main CFD Forum	0	July 1, 2009 15:41
Problem in running fluent 6.3 (64 bit) on ubuntu 8.1 (64 bit)	Mir5	FLUENT	3	April 29, 2009 10:32