Fluent Force Report

maharvey · April 8, 2010, 10:11

Hello,
I am running a simple wind flow simulation for a 25 inclined plane to find the force of lift to compare with what I calculated with a by hand.
The lift force I obtain using Fluent differs greatly and the values that it gives me are much below what it should be.

My setup:
20mph wind flow over a 1'X1' 25 degree inclined plane

Anyone have any suggestions for getting Fluent to output realistic values for forces?

maharvey · April 12, 2010, 12:18

No Suggestions?

Edu-R · April 12, 2010, 13:06

Hi Maharvey!

Have you defined the lift in the Z axis? Because Fluent calculates the lift in the Y axis

Regards!

-Edu-

April 8, 2010, 10:11	Fluent Force Report	#1
maharvey New Member Mark Harvey Join Date: Sep 2009 Posts: 5 Rep Power: 16	Hello, I am running a simple wind flow simulation for a 25 inclined plane to find the force of lift to compare with what I calculated with a by hand. The lift force I obtain using Fluent differs greatly and the values that it gives me are much below what it should be. My setup: 20mph wind flow over a 1'X1' 25 degree inclined plane Anyone have any suggestions for getting Fluent to output realistic values for forces?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent connection with simulink by TCP/IP	Tanktruck	Fluent UDF and Scheme Programming	1	June 28, 2009 12:56
Problems in lauching FLUENT	Lourival	FLUENT	3	January 16, 2008 16:48
how to report center of pressure in FLUENT?	xiaofish	FLUENT	1	September 17, 2007 05:36
Force calculation in Fluent	Jason	FLUENT	0	February 15, 2005 16:15
Some help simulating Magnus Force using Fluent	Michele Spinolo	FLUENT	6	June 27, 2002 12:57

April 12, 2010, 12:18		#2
maharvey New Member Mark Harvey Join Date: Sep 2009 Posts: 5 Rep Power: 16	No Suggestions?

April 12, 2010, 13:06		#3
Edu-R Member Edu Join Date: Sep 2009 Posts: 36 Rep Power: 16	Hi Maharvey! Have you defined the lift in the Z axis? Because Fluent calculates the lift in the Y axis Regards! -Edu-