fluent 12.0--- list-remove: null list error

timbo · August 5, 2009, 11:22

hey,
I have created a 3d model of a solstice engine previously using fluent 6.3. Everything was working and I had successfully ran many cycles of mesh motion and simulations with it. I just now updated my account to fluent 12.0 and my model now no longer works... Every time I run a mesh motion I get the error "list-remove: null list" when I'm trying to activate a cell zone using the dynamic-mesh events...

I have never seen this error before and I am stumped on how to fix it. If anybody can help me or throw ideas my way it would be greatly appreciated. thanks

timbo · August 5, 2009, 11:51

please time is of the essence since I need to get this project done soon...

Filankes · April 23, 2010, 15:17

I have the same problem here, however, with different stupid warning about cell nodes on interfaces.

6.3.26 rulez.

August 5, 2009, 11:22	fluent 12.0--- list-remove: null list error	#1
timbo New Member Timothy Join Date: Aug 2009 Posts: 2 Rep Power: 0	hey, I have created a 3d model of a solstice engine previously using fluent 6.3. Everything was working and I had successfully ran many cycles of mesh motion and simulations with it. I just now updated my account to fluent 12.0 and my model now no longer works... Every time I run a mesh motion I get the error "list-remove: null list" when I'm trying to activate a cell zone using the dynamic-mesh events... I have never seen this error before and I am stumped on how to fix it. If anybody can help me or throw ideas my way it would be greatly appreciated. thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode!	alban	Fluent UDF and Scheme Programming	2	June 8, 2010 18:54
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
[Netgen] Compiling Netgen on Fedora Core is driving me crazy	jango	OpenFOAM Meshing & Mesh Conversion	3	November 9, 2007 13:29
Installation problem with GCC	Norma McKee (Mckee)	OpenFOAM Installation	10	March 4, 2007 07:09
Problems of Duns Codes!	Martin J	Main CFD Forum	8	August 14, 2003 23:19

August 5, 2009, 11:51		#2
timbo New Member Timothy Join Date: Aug 2009 Posts: 2 Rep Power: 0	please time is of the essence since I need to get this project done soon...

April 23, 2010, 15:17		#3
Filankes New Member Faraj Join Date: Feb 2010 Posts: 22 Rep Power: 16	I have the same problem here, however, with different stupid warning about cell nodes on interfaces. 6.3.26 rulez.