Boiling using VOF

asaleghahreman · May 7, 2010, 07:23

I am using VOF model,for modeling boiling in a horizontal tube,the flow is laminar,and the wall tempreture is 403 kelvin,water is saturated373 kelvin,but it doesnt work properly & doesnt show phase change,& volume fraction of phase 2nd is zero during the process.
I added a source term but it doesnt have good result,what can I do?

tanx alot

Roystan · May 8, 2010, 02:15

You should use UDF to definite the source term！

asaleghahreman · May 8, 2010, 14:32

Hi..
tanx for ur answer.
Would u pls explain more about how use udf for source term?
I marked source term in boundary condition for fluid..

May 7, 2010, 07:23	Boiling using VOF	#1
asaleghahreman New Member asal Join Date: Apr 2010 Posts: 11 Rep Power: 17	I am using VOF model,for modeling boiling in a horizontal tube,the flow is laminar,and the wall tempreture is 403 kelvin,water is saturated373 kelvin,but it doesnt work properly & doesnt show phase change,& volume fraction of phase 2nd is zero during the process. I added a source term but it doesnt have good result,what can I do? tanx alot

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A question about horizontal film boiling tutorial?	Asghari	FLUENT	3	September 23, 2016 14:18
Nucleate boiling using VOF	Akash	FLUENT	6	June 27, 2011 08:22
Using VOF for sloshing air-water boiling system	Dibakar Rakshit	FLUENT	0	March 12, 2008 08:40
VOF vs BOILING	greg	FLUENT	0	April 1, 2007 11:59
Difficult BCs about Freesurface Simulation by VOF	Yongguang Cheng	FLUENT	0	September 19, 2003 08:39

May 8, 2010, 02:15		#2
Roystan New Member Roystan Join Date: May 2010 Location: Where Posts: 3 Rep Power: 17	You should use UDF to definite the source term！

May 8, 2010, 14:32		#3
asaleghahreman New Member asal Join Date: Apr 2010 Posts: 11 Rep Power: 17	Hi.. tanx for ur answer. Would u pls explain more about how use udf for source term? I marked source term in boundary condition for fluid..