|
[Sponsors] |
May 31, 2010, 10:45 |
Flame Lift Off!!HELP!!
|
#1 |
New Member
ravi teja
Join Date: May 2010
Posts: 7
Rep Power: 15 |
Hi,
I am trying to simulate a simple 1 slot rectangular burner of length(x)=124mm and height(y)=115mm.In the centre of the length i have the burner slot(Boundary Condition=velocity inlet) of 3mm width through which i am sending methane+air 2 step at a velocity of 0.05m/s.Boundary Condition at y=115mm is "pressure outlet" The problem i am facing is that after ignition (1200K) although initially i have a nice symmetric flame, eventually after a 100 or so iterations the flame lifts off from above the burner slot moves to the top and finally gets extinguished. I was told that this happens if there are stagnation points near the inlet,but i dont have any place where velocity equals zero near the burner slot HELP!!!!I really need some advice. Thank You |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Saffman Lift Force: confused | CFD_MAN | FLUENT | 5 | September 9, 2010 05:51 |
Lifted flame simulation!!! | krishh | FLUENT | 1 | August 26, 2009 06:17 |
Thin foil analsis (sail) - Lift Coeff Problem | Kelvin | CFX | 3 | December 22, 2008 17:22 |
Lift force or coefficient of lift | Rola | FLUENT | 1 | November 12, 2006 14:29 |
Saffman Lift Force | CFD MAN | Main CFD Forum | 0 | November 26, 2002 19:26 |