 |
 |
 |
|
|
|
[Sponsors] | ||||
June 4, 2010, 14:22
|
Checking the Fluent results
|
#1 |
|
New Member
Acoidan Betancort Mondesdeoca
Join Date: Mar 2009
Posts: 14
Rep Power: 17  |
Hi there!
I'm doing my final degree project about a rear wing of an automobile. In the report I want to show that the Fluent code is connected to the theoretical results. In order to do that, I think about doing a simple 2D analysis of a known shape (eg. a semi-circle) or a NACA airfoil. Then I could check that the results I get on Fluent are similar to the theoretical ones. What do you think about it? Where can I get the theoretical results of known shapes and NACA airfoils? Thank you very much Last edited by AcoidanBM; June 10, 2010 at 14:00. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 04:20 |
| HELPInstallation on RedHat90 | booosix | OpenFOAM Installation | 8 | July 17, 2007 06:40 |
| Exporting temperature results fro fluent to Ansys | vinay kulkarni | FLUENT | 1 | February 21, 2007 03:31 |
| Fluent results: stagnation pressure greater .... | Amit Shrestha | FLUENT | 5 | December 8, 2005 08:01 |
| Poor Results with RSM in Fluent | boris | FLUENT | 0 | October 31, 2005 18:01 |
Linear Mode
