How to Use Experimental Data in Fluent?
Hi
I am a student and currently doing a research on a thermal management system of a cylindrical lithium ion battery. The discharge temperautre of the battery was measured experimentally and that was actually a temperature V.S time curve. I would like to know how I could put the whole set of temperature V.S time data into fluent to carry out my simulation? Thanks! Floyd |
I would like to know if it possible to use a time dependent heat source term in the simulation since I only see the constant source term setting. thank you!
|
Li-ion battery
Hi,
I would like to know , how to plot the C-rate graphs and voltage distribution using MSMD battery module in ANSYS fluent |
C-rate graphs and voltage distribution are using to estimate parameters for electro-chemical models
Best regards |
uselokar
Thanks for the reply
How we can plot the current distribution graphs which should show variation in cell bodies. |
Graphics -> contours -> User defined memory (under contours of) -> Magnitude of current density
Best regards |
Thanks! It works
|
i am simulating Li-ion battery after I pop-up the Run solution message reflects" zone 16 is not connected to conductive zone ". How to resolve this .Is their any option to resolve this error without changing the geometry.
|
as far as I know, usually the only way is to change geometry
without geometry I can't advice best regards |
1 Attachment(s)
I have attached a picture and i stuck with an error while simulating in ansys fluent. the file is attached below. How to solve the overlapping with interface zones
|
obviously you have problems with mesh.
Generate new one, first of all delete all contacts best regards |
Thanks I will try and let you know.
While simulation error shows : " Divergence detected AMG solver :temperature". How to get rid off from this error. |
I believe, that for your case this error comes from problem with mesh.
best regards |
All times are GMT -4. The time now is 18:57. |