T-Mixer simulation
Hello
I am simulating a T Mixer of two different reactants. I am using Eulerian multiphase model, with 3 phases - the two reactants and air. The first phase is air, because i am assuming that at a initial state the mixer is full of air. My doubt is i should assume this? or only two phases - the two reactants? Another point is the continuity equation dont converge. I am not sure if it is the mesh fault, but i have a skewness lower than 0.8... Thanks for advice Nuno |
No one to help me?
|
All times are GMT -4. The time now is 04:47. |