|August 12, 2010, 07:34||
Kenics mixer fluent setup
Join Date: Aug 2010
Posts: 5Rep Power: 8
I am new to CFD. Just started 3 months back.
I am doing a project to study simulations on kenics mixer. Kenics mixer basically is a static (not moving) mixer(cylinderical in shape and having blades inside in which two liquids are introduced and they are mixed due to blade orientation.
I have meshed and modelled the geometry.
I have read the case file, resizing of the grid has been done. i have defined the materials and have choosen multiphase VOF, laminar ,steady state model. I have also defined the phases.
Please let me know if the model is correct.
My main problem is Boundary conditions. When i go for it, i have given mass flow from both of my inlets of the two liquids. Since i am sending in top half of cylinder liquid-1 and liquid-2 in bottom half of cylinder , i set phase-1 mass flow rate = some value and phase-2 mass flow rate= 0 in fluid inlet-1. similarly i define phase-2 mass flow rate= some value and phase-1 mass flow rate= 0 in fluid inlet-2.
Please let me know if these Boundary condition are correct.
Assuming that the mixer will open to atmosphere, i have specified outlet pressure of the mixutre as atmospheric by giving pressure-outlet condition.
I initialize from fluid inlet-1.
My answers are totally wrong. They dont converge at all and reverse flow is also there.
Please somebody help.
Thanks for reading such a long story.
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem of running parallel Fluent on linux cluster||ivanbuz||FLUENT||12||November 16, 2016 14:38|
|[ICEM] Hexa mesh, curve mesh setup, bunching law||Anorky||ANSYS Meshing & Geometry||4||November 12, 2014 01:27|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Fluent 6.3.26 vs 12.1 and partition method||Anorky||FLUENT||0||April 27, 2010 10:55|
|RTD is single phase system in Kenics Mixer||vaibhav IIT Delhi||FLUENT||0||October 17, 2002 14:05|