Boundary conditions by UDF

s.sami · August 23, 2010, 11:29

Dear all,

I am new in CFD world. I want to write UDF for boundary conditions. My boundary conditions are as following:

at interface : Temperature fluid 1 = Temperature fluid 2
also for mass transfer : Relative humidity fluid 1= Relative Humidity fluid 2

I do not know, how can explain this relation by C program in UDF.

I appreciate if you kindly help me. please write or send me some examples.

Samaneh

Jade M · August 23, 2010, 15:19

Hi Samaneh,

Posts only need to be entered once, just so you know.

Why do you want to enter boundary conditions as UDFs? These are simple enough conditions that can be done within the menu system.

Good luck.

August 23, 2010, 11:29	Boundary conditions by UDF	#1
s.sami New Member Sami Join Date: Jul 2010 Posts: 5 Rep Power: 16	Dear all, I am new in CFD world. I want to write UDF for boundary conditions. My boundary conditions are as following: at interface : Temperature fluid 1 = Temperature fluid 2 also for mass transfer : Relative humidity fluid 1= Relative Humidity fluid 2 I do not know, how can explain this relation by C program in UDF. I appreciate if you kindly help me. please write or send me some examples. Samaneh

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mesh file for flow over a circular cylinder	Ardalan	Main CFD Forum	7	December 15, 2020 13:06
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	25	February 27, 2016 12:58
read boundary conditions with udf	Bernhardt	FLUENT	0	May 31, 2007 09:46
A problem about setting boundary conditions	lyang	Main CFD Forum	0	September 19, 1999 18:29

August 23, 2010, 15:19		#2
Jade M Senior Member Join Date: Feb 2010 Posts: 148 Rep Power: 18	Hi Samaneh, Posts only need to be entered once, just so you know. Why do you want to enter boundary conditions as UDFs? These are simple enough conditions that can be done within the menu system. Good luck.