 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2010, 03:15
|
Symmetry surface
|
#1 |
|
Member
novice
Join Date: Nov 2009
Posts: 33
Rep Power: 16  |
Hi All,
I want to simulate a flow through an openchannel to get the headloss values. Should i consider a two phase model or define the freesurface as symmetry surface and simulate a single phase model??? Will there be any difference in the pressure calculations if i consider a symmetry surface in place of the free surface of the open channel. Thanks in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
