Too high values of temperature, pressure and velocity

valahian1 · January 22, 2015, 11:03

Hello to all of you!
I try to model (in FLUENT 15.0.0) an explosion of air-methane stoichiometric composition in a pipe with a closed end. I used Composition PDF Transport, Eulerian, Chemkin databasis and spark ignition. The mixture ignites well and burns, but it reaches very high temperatures (5000K - the limit imposed by program), pressures (about 2100000Pa) and velocities (greater than 3000m/s). I modified up and down the values in Arrhenius equation of Chemkin mechanism, but I obtained same results.
Have you any idea how to reduce those values?
Thank you!

hazwani fatihah · July 1, 2015, 03:53

hi nick,

Did you get the solution?I have a same problem. I intend to simulate gas explosion behavior involving premixed methane/air mixture in a closed straight pipe...i really have no idea how to set the concentration (fuel/air mixture) inside the closed pipe prior ignition as the pipe contains no inlet or outlet BC..... ..also I am not sure how to simulate ignition initiation inside the pipe..

Do you have any idea on this problem?

Thanks

January 22, 2015, 11:03	Too high values of temperature, pressure and velocity	#1
valahian1 Member Nick Join Date: Feb 2012 Posts: 33 Rep Power: 14	Hello to all of you! I try to model (in FLUENT 15.0.0) an explosion of air-methane stoichiometric composition in a pipe with a closed end. I used Composition PDF Transport, Eulerian, Chemkin databasis and spark ignition. The mixture ignites well and burns, but it reaches very high temperatures (5000K - the limit imposed by program), pressures (about 2100000Pa) and velocities (greater than 3000m/s). I modified up and down the values in Arrhenius equation of Chemkin mechanism, but I obtained same results. Have you any idea how to reduce those values? Thank you!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pressure Inlet VS velocity Inlet difference	Mohsin	FLUENT	9	January 4, 2021 10:34
Neumann pressure BC and velocity field	Antech	Main CFD Forum	0	April 25, 2006 02:15
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11
what the result is negatif pressure at inlet	chong chee nan	FLUENT	0	December 29, 2001 05:13

July 1, 2015, 03:53		#2
hazwani fatihah New Member hazwani Join Date: Nov 2014 Posts: 15 Rep Power: 11	hi nick, Did you get the solution?I have a same problem. I intend to simulate gas explosion behavior involving premixed methane/air mixture in a closed straight pipe...i really have no idea how to set the concentration (fuel/air mixture) inside the closed pipe prior ignition as the pipe contains no inlet or outlet BC..... ..also I am not sure how to simulate ignition initiation inside the pipe.. Do you have any idea on this problem? Thanks