 |
 |
 |
|
|
|
[Sponsors] | ||||
October 13, 2010, 06:45
|
vof model with a moving mesh
|
#1 |
|
New Member
Join Date: Apr 2010
Posts: 10
Rep Power: 17  |
Hi,
I am trying to simulate the interface water-air on a rotating disk where the water flow is fed at the center of the disk. I need to know the heigth and the shape of the water film on the disk. I'm using the VOF model but I am not able to make the disk rotating and moreover I would like to run the simulation on a steady state formulation but the simulation does not reach the convergence. Someone can give me any advices? Thank you in advance Benedetta |
|
|
|
|
|
October 13, 2010, 12:49
|
|
#2 |
|
Senior Member
Jouke de Baar
Join Date: Oct 2009
Posts: 127
Rep Power: 18 |
Perhaps you could use:
define > boundary conditions > [your disk] > momentum > moving wall > rotational Good luck! |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit problems | Althea | FLUENT | 22 | January 4, 2017 04:19 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
| Question on InterFoam moving mesh capabilities | ziv | OpenFOAM Running, Solving & CFD | 0 | April 23, 2008 10:11 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
| Moving Mesh Problem in Unix Platform | Arnab | Siemens | 3 | August 16, 2004 09:59 |
Linear Mode
