|
[Sponsors] |
November 21, 2010, 12:18 |
How to draw 2D VAWT in Wrorkbench-fluent
|
#1 |
New Member
Low Chee Boon
Join Date: Nov 2010
Posts: 3
Rep Power: 15 |
Hi , everyone. im new in Ansys. i have no idea how to draw a 2D VAWT. can anyone teach me ??
1st i select the Fluidflow(fluent) to project schematic. start the geometry. i draw in x-y plane and extrude 1 to Z-axis. and this method is i saw from others post. is it right ?? if it right. what is the next step ? thx for looking at my problem. boon |
|
November 21, 2010, 18:22 |
|
#2 |
New Member
Low Chee Boon
Join Date: Nov 2010
Posts: 3
Rep Power: 15 |
T.T
did anyone can tell me where can learn it ?? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
to draw tech plot using fluent results(case& data) | madhuri | FLUENT | 2 | July 18, 2007 13:43 |