|
[Sponsors] |
December 9, 2010, 06:19 |
how to choose the fluid volume
|
#1 |
New Member
Join Date: Dec 2010
Posts: 1
Rep Power: 0 |
Hi
I have to simulate somethink similar to an radial fan. I already have the "steel-model" made in Inventor 3D. There are openings which I want to use as inlet and outlets. But how can I coose the volume of the fluid. Fluent automaticly chooses the steel-parts as my fluid region. This cannot be too hard?? thanks for answering or tips. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
There is no fluid volume in the project | Giron | FloEFD, FloWorks & FloTHERM | 5 | December 30, 2022 08:58 |
dynamic mesh - sphere falling through fluid volume accelerated by gravity onely. | alexmeier | FLUENT | 1 | June 26, 2010 08:33 |
[Commercial meshers] CuBit | t42 | OpenFOAM Meshing & Mesh Conversion | 6 | July 10, 2008 07:51 |
Volume of Fluid help please! | Gareth Uglow | FLUENT | 8 | February 13, 2008 12:15 |
Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |