Grid seen in contour plots

swati_mohanty · December 18, 2010, 07:21

When I display a 2D contour plot for the interior with "filled" option and without "draw grid" , I get a contour plot with colored mesh which is not filled. could anybody help.

Thanx

Sm

skris2009 · December 18, 2010, 12:02

Hi,

When you display contours in 2D, by default (with no surface selected), the contours are displayed on the 'default interior' surface.

So, deselect 'default interior' surface, and you should be able to see just the contours, without the mesh. Same goes for vector, pathlines display too.

Hope this helps.

swati_mohanty · December 23, 2010, 07:37

Thanx Soumya, had forgotten this since I am doing 2d simulation after a long gap.
sm

gfoam · August 14, 2013, 12:06

Thanks, this served to me a lot

December 18, 2010, 07:21	Grid seen in contour plots	#1
swati_mohanty New Member sm Join Date: Jun 2009 Posts: 15 Rep Power: 16	When I display a 2D contour plot for the interior with "filled" option and without "draw grid" , I get a contour plot with colored mesh which is not filled. could anybody help. Thanx Sm

December 18, 2010, 12:02		#2
skris2009 New Member Sowmya K Join Date: Nov 2009 Posts: 22 Rep Power: 16	Hi, When you display contours in 2D, by default (with no surface selected), the contours are displayed on the 'default interior' surface. So, deselect 'default interior' surface, and you should be able to see just the contours, without the mesh. Same goes for vector, pathlines display too. Hope this helps. jpo, kapet3, yashganatra and 2 others like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Contour Plots Troubleshooting	derz	CFX	7	November 21, 2010 10:08
vector plots and contour plots do not match	swati_mohanty	FLUENT	1	August 26, 2010 05:53
drawing of contour plots	chinthakindi	Main CFD Forum	1	April 27, 2004 04:33
Local surface contour line plots	Nandu	FLUENT	0	November 9, 2003 23:26
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 05:59

December 23, 2010, 07:37		#3
swati_mohanty New Member sm Join Date: Jun 2009 Posts: 15 Rep Power: 16	Thanx Soumya, had forgotten this since I am doing 2d simulation after a long gap. sm

August 14, 2013, 12:06		#4
gfoam Senior Member Gonzalo Join Date: Mar 2011 Location: Argentina Posts: 122 Rep Power: 16	Thanks, this served to me a lot