 |
 |
 |
|
|
|
[Sponsors] | ||||
simulate wind tunnel and meshing....need some help |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 27, 2010, 17:02
|
simulate wind tunnel and meshing....need some help
|
#1 |
|
New Member
abishai murday
Join Date: Dec 2010
Posts: 23
Rep Power: 15  |
Hi everyone
I have an airfoil naca 0015 extruded in solidworks. its been tested in a wind tunnel for ground effect and now i want to simulate it in fluent and compare results. i am really a newbi, could anyone tell me a bit more about the type of meshing i need to simulate the wind tunnel. the wing has been tested in 3d so ill have to mesh in 3d right or 2d ? Do i have to mesh in 2d first and extrude in 3d??I am still in doubt whether to use gambit or ICEM cfd to mesh....any suggestions would really help me thank you |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind Tunnel Contraction Modelling | josh_k | Siemens | 1 | April 18, 2011 17:21 |
| 3D wing + wind tunnel hexa structured meshing | icemaniac178 | ANSYS Meshing & Geometry | 9 | October 28, 2010 10:37 |
| Meshing Wind Tunnel | Nazo | FLUENT | 0 | October 18, 2007 11:24 |
| Simulating a Göttingen type wind tunnel in FLUENT | Chris | FLUENT | 3 | December 4, 2006 18:33 |
| DELTA SHAPE FLAP IN WIND TUNNEL IMPORTANT!! | eddie farid | FLUENT | 6 | January 5, 2006 09:24 |
Linear Mode
