 |
 |
 |
|
|
|
[Sponsors] | ||||
January 11, 2011, 23:33
|
contour level
|
#1 |
|
Senior Member
raymond
Join Date: Nov 2009
Posts: 149
Rep Power: 18  |
when checking the velocity of a fluid, result shown as below:
Contour level 0, value in [1.2e-05, 0.017093999] the velocity is between the range [1.2e-05, 0.017093999], what will the best representative velocity for this range? Thanks for help. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] sMH refinement level | subhkirti | OpenFOAM Meshing & Mesh Conversion | 0 | October 13, 2010 05:10 |
| [snappyHexMesh] snappyHexMesh - Refinement Level | andrea.pasquali | OpenFOAM Meshing & Mesh Conversion | 5 | February 8, 2010 04:08 |
| Print contour level in TUI | Shamoon Jamshed | FLUENT | 1 | August 6, 2009 03:25 |
| Level set vs VOF | steve | Main CFD Forum | 11 | September 16, 2008 01:22 |
| Relaxation factors | Vidya Raja | FLUENT | 7 | September 26, 2006 21:00 |
Linear Mode
