Multiphase Convergence Problem using VOF in ANSYS 13

itsuetian@hotmail.com · January 27, 2011, 18:35

Hi all,
I am Currently working on the Project Called Hydroplanning using Multiphase (Air and water) using VOF Method.My basic goal is to find the Lift and drag forces of the Air Plane Landing wheel which is moving in radial direction and between the ground which contains layer of the water 2 cm thick.Now ground Air and Water all are moving with Same Speed. .I have two fluid here one is Air and the other is Water.But the Problem is that my Solution is not getting Convergence.I have run it for days and days and it goes on without getting Convergence.So please tell me how to get that.What i did is
1-Created A tyre of .60m dia.
2-Created Enclousre arround it.
3-I keep the tyre 2cm from the ground(that is the layer of water)
4-Then i did Meshing using Patch conforming Method.
5-I did Name Selection.I Selected only one inlet for both Air and Water.
6-In Setup i Selected VOF/Implicit...
7-Selected boundary Conditions
8-i Selected very Short time Steps of .00001 and No of time Steps 1000.

I really apprciate your feed back.
Regards,
Noni

k.baker · January 28, 2011, 02:22

May u send illustrated plot for your geometry and BC to get better understanding of your problem.

January 27, 2011, 18:35	Multiphase Convergence Problem using VOF in ANSYS 13	#1
itsuetian@hotmail.com New Member Farhan Join Date: Dec 2010 Posts: 4 Rep Power: 15	Hi all, I am Currently working on the Project Called Hydroplanning using Multiphase (Air and water) using VOF Method.My basic goal is to find the Lift and drag forces of the Air Plane Landing wheel which is moving in radial direction and between the ground which contains layer of the water 2 cm thick.Now ground Air and Water all are moving with Same Speed. .I have two fluid here one is Air and the other is Water.But the Problem is that my Solution is not getting Convergence.I have run it for days and days and it goes on without getting Convergence.So please tell me how to get that.What i did is 1-Created A tyre of .60m dia. 2-Created Enclousre arround it. 3-I keep the tyre 2cm from the ground(that is the layer of water) 4-Then i did Meshing using Patch conforming Method. 5-I did Name Selection.I Selected only one inlet for both Air and Water. 6-In Setup i Selected VOF/Implicit... 7-Selected boundary Conditions 8-i Selected very Short time Steps of .00001 and No of time Steps 1000. I really apprciate your feed back. Regards, Noni

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Convergence problem	suthichock	Main CFD Forum	27	May 11, 2009 07:05
Convergence problem for P1 & Energy	HP	FLUENT	5	May 21, 2005 15:01
convergence problem	limseokmin	FLUENT	3	November 14, 2004 12:43
Convergence problem	Praveen	FLUENT	0	September 15, 2000 06:34
convergence problem with SIMPLER	NURAY KAYAKOL	Main CFD Forum	1	February 24, 1999 13:43

January 28, 2011, 02:22		#2
k.baker New Member Khalid Baker Join Date: Mar 2009 Posts: 19 Rep Power: 17	May u send illustrated plot for your geometry and BC to get better understanding of your problem.