 |
 |
 |
|
|
|
[Sponsors] | ||||
February 15, 2011, 12:28
|
FLUENT dynamic mesh set-up question
|
#1 |
|
New Member
Robert
Join Date: May 2009
Posts: 15
Rep Power: 16  |
Hello...
I am trying to set up a case where the kinematics of the vehicle is already defined in a file (i.e. X,Y,Z,Vx,Vy,Vz,coordinate transformation matrix, etc...). The domain will be moved in rigid-body fashion, i.e. no re-meshing. So I read in Vx,Vy,Vz as a profile, specified my cell zone as moving mesh type. I have enabled dynamic mesh and defined the zone motion to my profile. So when I tried to preview the mesh motion, the domain is moving with the prescribed velocity components. Now I want to change its attitude as the domain changes angle in time. I have the transformation coefficient matrix available, but how do I implement that into the FLUENT solver? Last edited by ral007; February 19, 2011 at 11:36. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [ICEM] Question about boundary type recognition when import mesh from IcemCFD to Fluent | dean | ANSYS Meshing & Geometry | 2 | April 23, 2010 10:17 |
| reversed flow in unsteady simulation with dynamic mesh (fluent 12.1) | zhaoyu_001 | FLUENT | 0 | April 7, 2010 00:24 |
| Dynamic mesh + apaption in Fluent 12 ? | klunker | FLUENT | 0 | September 23, 2009 08:19 |
| Problem with Dynamic Mesh and Fluent | Claude | Main CFD Forum | 0 | December 12, 2006 06:03 |
Linear Mode
