Set a maximum particle number on a surface injection

benjamin16 · March 10, 2011, 05:29

Hi,

I would like to inject a specific number of particles through a surface. I tried to use the injection panel, with mass flow rate, diameter and material but It doesn't work, the number of particles is still growing.

How can I set a maximum number of particles ??

Thank you in advance

Ben

Amir · March 10, 2011, 10:36

Hi Ben,
to set specific particle stream over a surface, you can build a virtual plane in surface->plane and it should be bounded and also sampled. if you set this surface as your injection plane, the total particle stream will be equal to sample points number.

touyet · January 19, 2016, 00:35

Hi Amir
I have question with your solution
I made virtual bounded plane with sample point in fluent. but where can I select this virtual plane as injection plane. I entered set injection properties tab and select injection type as surface. there is no virtual plane in surfaces.
How can I deal with it?

March 10, 2011, 05:29	Set a maximum particle number on a surface injection	#1
benjamin16 New Member Join Date: Mar 2011 Posts: 1 Rep Power: 0	Hi, I would like to inject a specific number of particles through a surface. I tried to use the injection panel, with mass flow rate, diameter and material but It doesn't work, the number of particles is still growing. How can I set a maximum number of particles ?? Thank you in advance Ben

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Simple stadium using searchableCylinder	swyngaard	OpenFOAM Meshing & Mesh Conversion	3	February 1, 2018 19:43
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[snappyHexMesh] jagged, ragged edges...	ziemowitzima	OpenFOAM Meshing & Mesh Conversion	138	July 23, 2012 23:41
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
Unaligned accesses on IA64	andre	OpenFOAM	5	June 23, 2008 10:37

March 10, 2011, 10:36		#2
Amir Senior Member Amir Join Date: May 2009 Location: Montreal, QC Posts: 735 Blog Entries: 1 Rep Power: 22	Hi Ben, to set specific particle stream over a surface, you can build a virtual plane in surface->plane and it should be bounded and also sampled. if you set this surface as your injection plane, the total particle stream will be equal to sample points number.

January 19, 2016, 00:35		#3
touyet New Member Yoon Join Date: Mar 2015 Location: Seoul Posts: 22 Rep Power: 11	Hi Amir I have question with your solution I made virtual bounded plane with sample point in fluent. but where can I select this virtual plane as injection plane. I entered set injection properties tab and select injection type as surface. there is no virtual plane in surfaces. How can I deal with it?