How could I enable the 'Turbulence' in the Boundary Conditons?

Jongmin Choi · February 9, 2016, 07:51

Hi.

Sometimes I couldn't see the 'Turbulence' box in inlet or outlet boundary conditions.

I will show specifically what I'm saying in attached photoes. I will check the 'Turbulence' box on the one of the photoes and also upload the photo on that I couldn't find the 'Turbulence' box

Could you explain how I can make the 'Turbulence' in boundary conditions shown?

Thank you.

`e` · February 9, 2016, 15:31

A turbulence model must be selected to apply turbulent boundary conditions, which one have you enabled? If you're using the laminar or inviscid models then turbulent boundary conditions are not applicable.

Jongmin Choi · February 10, 2016, 01:14

Quote:

Originally Posted by `e`

A turbulence model must be selected to apply turbulent boundary conditions, which one have you enabled? If you're using the laminar or inviscid models then turbulent boundary conditions are not applicable.

Yeah. When I choosed viscous model, I finally could enable the 'turbulence' box!!

Thank you so much!! :^)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Basic Nozzle-Expander Design	karmavatar	CFX	20	March 20, 2016 08:44
Problem in setting Boundary Condition	Madhatter92	CFX	12	January 12, 2016 04:39
Difficulty In Setting Boundary Conditions	Moinul Haque	CFX	4	November 25, 2014 17:30
Setting rotating frame of referece.	RPFigueiredo	CFX	3	October 28, 2014 04:59
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 00:00

February 9, 2016, 15:31		#2
`e` Senior Member Join Date: Mar 2015 Posts: 892 Rep Power: 18	A turbulence model must be selected to apply turbulent boundary conditions, which one have you enabled? If you're using the laminar or inviscid models then turbulent boundary conditions are not applicable.