 |
 |
 |
|
|
|
[Sponsors] | ||||
March 21, 2011, 18:14
|
Dynamic mesh and boundary layer
|
#1 |
|
Member
Join Date: Apr 2010
Location: Pisa / Italy
Posts: 62
Rep Power: 17  |
hi all,
i'm simulating an impeller using dynamic mesh. My problem is that if i use boundary layer mesh (prismal mesh) around the blades after few time step i get "negative cell volume". What can i do? I'd like to avoid enclosing blades in a zone apart thanks for your help |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| [snappyHexMesh] SnappyHexMesh - no layer added | bejbro | OpenFOAM Meshing & Mesh Conversion | 5 | February 1, 2020 21:05 |
| How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh | tomyangbath | FLUENT | 18 | October 12, 2016 07:57 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 14:47 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
1Likes
Linear Mode
