|
[Sponsors] |
August 30, 2019, 18:15 |
Getting two surface meshes for some reason
|
#1 |
New Member
Spencer
Join Date: Aug 2016
Posts: 4
Rep Power: 9 |
I am getting what seems to be 2 surface meshes that are layered on top of one another an I don't know what is causing it. I am meshing an inverted A-18 airfoil in ground effect using ANSYS 2019 R2 under the "Watertight Geometry" workflow tab in Fluent Meshing.
Capture 2.jpg Capture 3.jpg Capture 5.jpg Capture 6.jpg Capture 7.jpg |
|
September 2, 2019, 01:07 |
|
#2 |
Member
|
can u send stp file of geom to check .. midhun6189@gmail.com
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free surface sensitivity - drag coefficient & mesh sizes | SYL | Main CFD Forum | 1 | May 15, 2023 11:53 |
Comsol (4.3): convert parametric surface into block? | sgalaz | COMSOL | 0 | November 9, 2012 09:20 |
Differents Meshes for an unique surface | Tati | CFX | 9 | December 8, 2009 11:36 |
[Technical] Mesh generation from dirty surface meshes | bastil | OpenFOAM Meshing & Mesh Conversion | 9 | December 10, 2007 11:17 |
Empty surface in sliding meshes. | Pierre Ricco | FLUENT | 2 | March 14, 2001 16:01 |