Dust explosion using Fluent

sir · April 19, 2011, 20:33

Hi all,

I'm a new user of CFD and FLUENT. My research is to do modeling and simulation of dust explosion inside close vessel. Now, I'm getting confused

how to start, how to define dust-air mixture to start the simulation? and what is the best method to start..I really hope somebody will help me to figure out the the right path to start.

sepideh55 · January 8, 2014, 10:51

does anybody know that how can i model dust explosion in Fluent?

Vaaj · August 21, 2017, 09:46

Hey, I know it is too late. But I would like to know whether you guys found a way.

April 19, 2011, 20:33	Dust explosion using Fluent	#1
sir New Member sirly Join Date: Apr 2011 Posts: 3 Rep Power: 15	Hi all, I'm a new user of CFD and FLUENT. My research is to do modeling and simulation of dust explosion inside close vessel. Now, I'm getting confused how to start, how to define dust-air mixture to start the simulation? and what is the best method to start..I really hope somebody will help me to figure out the the right path to start. Fazila Burn likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stopping a Fluent batch job AND saving the data! Possible?	Volker Pawlik	FLUENT	13	December 28, 2020 04:16
How to open Icem mesh in Ansys Fluent?	emmkell	FLUENT	27	February 6, 2018 03:34
Fluent 6.3 32bit vs Fluent 12.0 64bit	ibex7	FLUENT	7	April 18, 2011 02:44
Fluent 12.0 is worst then Fluent 6.2	herntan	FLUENT	5	December 14, 2009 02:57
How to simulate an explosion in a tube?	tp9180188	FLUENT	0	September 18, 2009 11:10

January 8, 2014, 10:51		#2
sepideh55 New Member sepideh Join Date: Oct 2013 Location: belgium Posts: 3 Rep Power: 12	does anybody know that how can i model dust explosion in Fluent?

August 21, 2017, 09:46		#3
Vaaj New Member Bharatvaaj Join Date: Feb 2017 Posts: 23 Rep Power: 9	Hey, I know it is too late. But I would like to know whether you guys found a way.