|
[Sponsors] |
April 27, 2011, 23:23 |
meshing a wing sail
|
#1 |
Member
Linyx
Join Date: Mar 2011
Posts: 31
Rep Power: 15 |
I have a problem meshing this wing sail using gambit see pic
The slat is an arc, in the middle the rigid wing sail is a NACA0030 airfoil, and the soft sail behind is a parabola line(assumed to have been loaded by wind). The soft sail is very thin, and I assume it as a line in gambit(2d), I create a circle domain to calculate, here comes a question that how can I block and mesh it? this is quite a complex geometry,can anybody suggest a strategy? Thanks a lot for paying attention! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
meshing a wind sail | linyx | FLUENT | 7 | April 6, 2011 02:57 |
Wing meshing help...... | ACER | Main CFD Forum | 0 | January 31, 2011 18:20 |
Meshing for 3D wing with tubercle on the leading edge in GAMBIT | nvtrieu | FLUENT | 0 | August 14, 2010 10:13 |
[ICEM] Problems about meshing the swept wing with cylinder end cap | kepeng | ANSYS Meshing & Geometry | 3 | June 15, 2010 05:21 |
Meshing of a 2-D Sail Model | ersahino | Siemens | 2 | April 9, 2010 16:45 |