[zhiyii]

hello,
i have a problem.i need to monitor the date(like mass flow rate) in the cross section of the middle inlet(there are 3 inlet), like the pic of the simple cause of my model in FLUENT(note:not in the inlet boundary).
my model is 3D.how can i create a domain in the monitor location.i use the plane surface tool to create plane pass this location,but the plane pass also pass through the other two inlet.


if you cannot see pic ,click here please:
http://www.flickr.com/photos/6239250...in/photostream

[-mAx-]

try to combine the plane surface tool with clip tool
You can narrow your surface between 2 iso values (x-y or z-coordinate, or whatever)

[zhiyii]

thank you

i have done fellow your advise and get it!

Originally Posted by -mAx-

try to combine the plane surface tool with clip tool
You can narrow your surface between 2 iso values (x-y or z-coordinate, or whatever)