|
[Sponsors] |
May 1, 2011, 09:48 |
creat a monitor domain in 3D model
|
#1 |
New Member
cz
Join Date: Apr 2010
Posts: 3
Rep Power: 16 |
hello,
i have a problem.i need to monitor the date(like mass flow rate) in the cross section of the middle inlet(there are 3 inlet), like the pic of the simple cause of my model in FLUENT(note:not in the inlet boundary). my model is 3D.how can i create a domain in the monitor location.i use the plane surface tool to create plane pass this location,but the plane pass also pass through the other two inlet. if you cannot see pic ,click here please: http://www.flickr.com/photos/6239250...in/photostream |
|
May 2, 2011, 02:30 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
try to combine the plane surface tool with clip tool
You can narrow your surface between 2 iso values (x-y or z-coordinate, or whatever)
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
May 2, 2011, 06:29 |
|
#3 |
New Member
cz
Join Date: Apr 2010
Posts: 3
Rep Power: 16 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem on EDC model for coal combustion | lei | FLUENT | 4 | September 3, 2015 09:39 |
question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 04:41 |
Centrifugal Pump and Turbulence Model | Michiel | CFX | 12 | January 25, 2010 03:20 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |
Grid resolution for full-scale and down scaled model | gravis | Main CFD Forum | 0 | October 2, 2009 10:27 |