|
[Sponsors] |
May 8, 2011, 07:37 |
creating porosity in a channel
|
#1 |
New Member
Join Date: Mar 2011
Posts: 1
Rep Power: 0 |
Hi everyone,
I am dealing with the problem of metal foam in a rectangular duct. I want to simulate foam as a porous media. I specified BC as porous jump in GAMBIT. when I try to import it to FLUENT 6.3.26 I get to error "Cannot change porous_jump to porous-jump because there is only one adjacent cell thread." Nitin Pathak said that "This error means that u r applying porous jump BC on extreme boundary..on the other side of porous jump there is nothing..actually porous jump can be applied on a face which connects two media..one side u have fliud flow nd other side some porous media like sand. then it will work regards nitin said the solution"... But I couldnt solve the problem. Are there any suggestions??? Sincerely... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Porosity field in Fluent | wojciech | FLUENT | 1 | September 20, 2010 11:19 |
Creating a grid for a channel inside a brick | sanin | FLUENT | 0 | November 6, 2008 08:03 |
Creating a flow geometry with domains with different porosity | arkasshka | OpenFOAM Running, Solving & CFD | 15 | December 7, 2007 02:11 |
Problems with Meshing: Collapsed Cells | Emmanuel Resch | Siemens | 1 | July 30, 2007 03:02 |