 |
 |
 |
|
|
|
[Sponsors] | ||||
May 11, 2011, 00:33
|
Fluent won't Y+ adapt
|
#1 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 26  |
Hey guys,
Made a model of a car with a spinning wheel (one only - baby steps). The pressures on the car look way wrong; most of the car is extremely high, but the wheel has very low pressure. The velocity streamlines look alright. Funny thing is when I run the y+ adaption routine, fluent marks ~500000 cells for coarsening (using ke), but it never changes any. It always reports 0 cells are changed. Anyone ever run into this before? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 05:16 |
| Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
| Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 07:24 |
| Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 03:57 |
| Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 17:48 |
Linear Mode
