|
[Sponsors] |
June 7, 2011, 22:00 |
Need help creating geometery
|
#1 |
New Member
Farhan
Join Date: Dec 2010
Posts: 4
Rep Power: 15 |
Hi all,
I am currently working on the fluid mechanics project. The project is about to calculate the hydroplanning forces on the moving wheel of the car. I have to work with multiphase flow (Air + water). The schematic view of the problem is attacged The Bounday Conditions are 1-Air and water both are moving with the same speed. 2-The tire is rotating and moving at the same time. 3.Ground and walls are moving. Please tell me how can i use Split command to split the box in two segments. I am using ANSYS 13 for that. Apprecite your suggestion |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Problems in creating a wedge type mesh | Joscha | OpenFOAM Meshing & Mesh Conversion | 28 | August 3, 2019 07:59 |
[Commercial meshers] Fluent msh and cyclic boundary | cfdengineering | OpenFOAM Meshing & Mesh Conversion | 48 | January 25, 2013 03:28 |
[blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 12:46 |
Problems with Meshing: Collapsed Cells | Emmanuel Resch | Siemens | 1 | July 30, 2007 03:02 |
Gerris software installation | mer | Main CFD Forum | 2 | November 12, 2005 08:50 |