 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2011, 02:05
|
Turbulent Boundary Conditions
|
#1 |
|
Senior Member
Join Date: Mar 2011
Location: Germany
Posts: 552
Rep Power: 20  |
hi all, i am new user of fluent and these i am doing a project to calculate CL,CD,CM over a general stepped(diameter is differnet at differnet locations) missile body at 2 degree AOA and M=2. Here i want to ask what is the correct method of specifying turbulent boundary conditions. I know there are 4 methods to specify them. What is the best method for my case??? how much they affect the accuracy of our results??? i went through the fluent manual and only came to know the method to specify Turbulent length scale i.e l=0.4*$($ is Bounday layer thickness) and Turbulent viscosity ration b/w 1-10. What is the best value for my case?? 1 or 10??? in what cases low values of turbulent viscosity ratio are better or when high values are better??? what is the method or formula to specify k and epsilon??? what is the method or formula to specify turbulence intensity???
Thanx in advance |
|
|
|
|
|
June 20, 2011, 13:45
|
|
#2 |
|
Senior Member
Join Date: Mar 2011
Location: Germany
Posts: 552
Rep Power: 20 |
somebody please take out some time and clarify my questions, i shall b very thankful to that person
|
|
|
|
|
|
|
June 24, 2011, 02:28
|
|
#3 |
|
Senior Member
Join Date: Mar 2011
Location: Germany
Posts: 552
Rep Power: 20 |
no replies yet, i am stilling waiting
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
| [Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
| Help with boundary conditions | Dan | CFX | 0 | April 3, 2006 11:32 |
Linear Mode
