 |
 |
 |
|
|
|
[Sponsors] | ||||
June 22, 2011, 07:45
|
dynamic mesh: cells get crowded....Help
|
#1 |
|
Member
anonymous
Join Date: Feb 2011
Posts: 50
Rep Power: 15  |
I was using dynamic mesh in my 2D model and it worked well. However, when I change a bit my model and refine my mesh, I get negative volume cells. From some reason during moving, the cells get crowded at a specific place and gernerate negative volume.
Does someone have an idea  ?????I am stuck!!!!! |
|
|
|
|
|
June 25, 2011, 02:43
|
|
#2 |
|
New Member
jiang li
Join Date: Jun 2011
Posts: 1
Rep Power: 0 |
in per time step is the convergence well?you can check the mesh and the setting of dynamic mech.
|
|
|
|
|
|
|
June 25, 2011, 14:27
|
|
#3 |
|
Member
anonymous
Join Date: Feb 2011
Posts: 50
Rep Power: 15 |
Thank you for your respond.
I am sure there are parametrs that are not defined well. I used layering remeshing ..and went through the tutorial It starts from the first time step that the cells are getting very small just but just in one point. It looks like it the remeshing at that point doesn't work well from some reason... |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
| Incylinder dynamic mesh with volumetric reaction | mas | FLUENT | 4 | May 3, 2012 10:22 |
| Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 23, 2010 23:53 |
| Dynamic Mesh with Boundary Layer | Marcell | FLUENT | 0 | March 11, 2009 08:40 |
| Add a layer of cells, dynamic mesh or ...? | Modisa | FLUENT | 1 | March 12, 2007 02:01 |
Linear Mode
