|
[Sponsors] |
June 13, 2011, 04:25 |
3D cylinder, dynamic radius
|
#1 |
New Member
|
could i change the radius of a cylinder while iterating? such as define_cg_motion macro could only change a particular dynamic zone with a velocity. is there any other macro could be used to change the radius of a cylinder? thank you.
|
|
July 1, 2011, 11:49 |
|
#2 |
Member
Adrien Lemoine
Join Date: Jun 2011
Location: Paris,France
Posts: 31
Rep Power: 14 |
To change a geometry while iterating you should not use DEGINE CG MOTION but DEFINE GRID MOTION.
Sincerly Adrien
__________________
------------------------------------------- Plz add reputation if the answer is correct A cœur vaillant rien d'impossible ------------------------------------------ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
[blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
dynamic mesh prob inside the cylinder | kantharao | FLUENT | 0 | May 30, 2008 06:36 |
Dynamic Mesh - Ball in Cylinder | Hamish | FLUENT | 5 | October 26, 2007 08:43 |
dynamic mesh for oscillating cylinder | gaetan | FLUENT | 0 | October 20, 2006 11:47 |