|July 11, 2011, 19:57||
Converged values and boundary conditions
Join Date: Jul 2011
Posts: 1Rep Power: 0
i was running a simulation and after the solution converged the results did not make sense.
the problem is that :
my inlet velocity condition is 1.96 m/s and
my outlet pressure condition is 0 guage pressure.
but the results after the convergence of the simulation did not match for either of the two , that is the inlet velocity and outlet pressure were not anywhere close to the boundary conditions.
can any1 tell me as to why that might be?
|July 21, 2011, 01:10||
Join Date: Mar 2009
Location: Indiana, US
Posts: 185Rep Power: 10
First of, your BC's cannot change during the solution, they are fixed values. I'll need more details on what you are analysing to help you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|Reading field values and setting them as boundary conditions||sega||OpenFOAM Running, Solving & CFD||1||July 7, 2009 06:18|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|