|
[Sponsors] |
July 26, 2011, 22:52 |
Stops responding after adaptation command!
|
#1 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
hello,
i've been doing some calculation on a remote cluster recently everything works fine. But when i decided to refine the mesh using the region adaptation command. Fluent stops responding after partitionning the grid , i don't really know if it's because of fluent or the cluster. i'm sure that it doesn't stop responding because it needs more time. It's just 20000 cell. Does somebody experience the same thing ? here's a screenshot of where it stops: 8 Stored Partitions: ---------------------------------------------------------------------- Collective Partition Statistics: Minimum Maximum Total ---------------------------------------------------------------------- Cell count 846096 846105 6768806 Mean cell count deviation -0.0% 0.0% Partition boundary cell count 5530 24576 136130 Partition boundary cell count ratio 0.7% 2.9% 2.0% Face count 2458746 2580047 20033170 Mean face count deviation -2.3% 2.5% Partition boundary face count 6457 40517 104559 Partition boundary face count ratio 0.3% 1.6% 0.5% Cell weights 8e+05 8e+05 7e+06 Mean cell weight deviation -0.0% 0.0% Partition neighbor count 1 4 ---------------------------------------------------------------------- Partition Method Principal Axes Stored Partition Count 8 Done. After Done. it doesn't respond anymore. does anybody had a similar problem ? Thanks in advance |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 05:41 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 22:45 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 05:26 |