Exporting transient simulation data for evey time step

mali28 · August 3, 2011, 10:22

Hi all,

In an unsteady simulation on Fluent and I would need to export a number of variables on a certain plane of the grid (x-,y- and z- velocities) every time step to be post-processed with another software.

So far I've exported data from steady simulations, at the end of them, once converged. However I've never done this before for unsteady simulations.

I do not want to use the auto save feature.

I would much appreciate any light you could give me on this.

Thanks.

Amir · August 3, 2011, 12:48

Hi,
I'm not sure but I think this capability is added to Ansys FLUENT 13, which you can export your desired data at each time step for other softwares; otherwise you can use journal file for your purpose.

Amir

August 3, 2011, 10:22	Exporting transient simulation data for evey time step	#1
mali28 Member Join Date: Jun 2011 Posts: 86 Rep Power: 16	Hi all, In an unsteady simulation on Fluent and I would need to export a number of variables on a certain plane of the grid (x-,y- and z- velocities) every time step to be post-processed with another software. So far I've exported data from steady simulations, at the end of them, once converged. However I've never done this before for unsteady simulations. I do not want to use the auto save feature. I would much appreciate any light you could give me on this. Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 06:24
Time step in transient simulation	shib	FLUENT	0	June 17, 2010 14:07
exporting data during a transient simulation	vishwa	FLUENT	0	April 20, 2009 12:54
transient behavior dependent on time step	Fab	Main CFD Forum	2	May 29, 2008 12:38
AMG versus ICCG	msrinath80	OpenFOAM Running, Solving & CFD	2	November 7, 2006 16:15

August 3, 2011, 12:48		#2
Amir Senior Member Amir Join Date: May 2009 Location: Montreal, QC Posts: 735 Blog Entries: 1 Rep Power: 24	Hi, I'm not sure but I think this capability is added to Ansys FLUENT 13, which you can export your desired data at each time step for other softwares; otherwise you can use journal file for your purpose. Amir