|August 17, 2011, 16:28||
Match Control and Periodic BC ANSYS 12.1
Join Date: Aug 2011
Posts: 6Rep Power: 7
I am trying to assign periodic BCs to two sides of an axially protruded circular sector that represents a segment of a cylindrical control volume. This thin (5 degree) slice will be used to solve a combustion problem.
When I try to use Match control in the meshing application I get a ludicrous error message: "Warning: The mesher was unable to successfully match the mesh for the following faces/edges. Please verify that the topology is the same shape and size. Also verify the position and orientation of any associated coordinate systems."
The shapes and sizes are identical: I used revolve to get the 3D part!
I have spent a lot of time with the user guide and have gotten nowhere.
How can I match these surfaces so that i can later assign periodic BCs during the setup step in Fluent?
|April 3, 2017, 03:42||
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 713Rep Power: 15
|Thread||Thread Starter||Forum||Replies||Last Post|
|Link faces meshes for periodic BC with ANSYS WORKBENCH||mawi01||ANSYS Meshing & Geometry||5||March 13, 2016 14:10|
|Periodic Interface (Ideal Gas) Massflow Control||Zigainer||CFX||0||July 25, 2011 11:43|
|[Other] Ansys meshing - periodic mesh for fluent||jsm||ANSYS Meshing & Geometry||4||September 24, 2010 14:25|
|periodic boundaries - flow through a net||PK||FLUENT||0||July 12, 2007 11:58|