|
[Sponsors] |
September 1, 2011, 13:07 |
gambit mesh error
|
#1 |
New Member
Parvin
Join Date: Aug 2011
Location: Iran
Posts: 6
Rep Power: 14 |
hi all
gambit gives following error when I use map scheme for a face: "number of intervals on method edges of face.. don't allow meshing using a scheme of map ." i post photos of my volume, can anybody say me how can i mesh it? |
|
September 2, 2011, 01:10 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
if you are talking about the top face, then you cannot mesh it with quad.
You need some decompositions (splits). But you may mesh it with quad-pave or of course tri. But it depends on what kind of 3d-mesh you want
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 2, 2011, 01:51 |
|
#3 |
New Member
Parvin
Join Date: Aug 2011
Location: Iran
Posts: 6
Rep Power: 14 |
thanks max.
can I first mesh the entire surface of the wing+winglet using with tri pave elements and then mesh the volume using with Hex/Map? |
|
September 2, 2011, 02:04 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
you mean you will have a cooper mesh (wedges)?
You could, but you need some splits especially at the bottom from your wing (there are some small entities which will give you troubles for sure). If you don't need absolutely a hexa mesh, I would suggest you tetra-hexcore mesh with size function on wing and a Boundary Layer. Should ask you less work than full hexa, or even cooper-mesh
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 06:42 |
checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
attach/detach (valve opening/closing) | phsieh2005 | OpenFOAM Running, Solving & CFD | 2 | March 21, 2009 05:18 |