two different two phase model
Hi
do u think its possible to use desceret particle model ( injection of water in fluid1) and vof model (fluid1 is in fluid2) at the same time in a domain ? thank you |
yes, it is possible, as a matter of fact manual also says so...
|
Hi
Thank you for reply, is it in help or user guide? |
user guide, but there is just a remark that it is possible. It depends on what you want to simulate...
|
hi,
that is like injection of water in a two phase flow (fluid 2 and fluid 3 while fluid 2 and 3 are modeled with VOF) |
then u need to write some UDF to provide coupling between DPM and VOF.
|
thank you, but could u explain a little bit more..
|
u did not described your problem in details, for this reason nobody here can help you here.
From my point of view, I can only tell you a general rule: 1) write UDF to for mass, momentum, energy transfer from DPM to VOF 2) make sure that everything is conserved (no sinks, sources) |
thank u for the clue..
the problem is injecting water in the domain of two fluids (fluid2 and fluid 3), the domain is a pipe.. fluid 2 and fluid 3 are modeled with VOF and the injection of water is modeled by DPM, |
All times are GMT -4. The time now is 10:39. |