how can i initialize after transient work?

emreg · November 14, 2011, 12:07

i would like to pass transient work after finishing the steady work.
firstly i made a steady solution in order to get an initialize point.

But now when i chhoose transient, it enforces me to initialize which means that i am losing the previous works

how can i solve this?

raj.cfd · November 14, 2011, 13:37

Probably you should be able to continue from the steady state results into transient straight away by choosing transient and then the time step size and the number of time steps along with inner iterations, unless and until you have gone wrong some where.

emreg · November 14, 2011, 15:51

yes. i hav just found the failure. Forcing the .dat file read is missed. i hav to be more careful..
thanks.

November 14, 2011, 12:07	how can i initialize after transient work?	#1
emreg Senior Member Emre G Join Date: May 2011 Location: Turkey Posts: 126 Rep Power: 14	i would like to pass transient work after finishing the steady work. firstly i made a steady solution in order to get an initialize point. But now when i chhoose transient, it enforces me to initialize which means that i am losing the previous works how can i solve this?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transient conduction possible in fluent?	jlefevre76	FLUENT	2	February 5, 2013 09:53
Transient post-processing, Time averaged pressure work	Turbomachine	CFX	1	January 3, 2011 17:01
transient results export	Joshua	CFX	2	July 4, 2007 18:14
Transient vs Steady State	Adam	CFX	1	April 12, 2007 11:34
Transient Inlet boundary condition - fully develop	Omer	CFX	3	November 28, 2006 16:22

November 14, 2011, 13:37		#2
raj.cfd New Member raj Join Date: Nov 2011 Posts: 22 Rep Power: 14	Probably you should be able to continue from the steady state results into transient straight away by choosing transient and then the time step size and the number of time steps along with inner iterations, unless and until you have gone wrong some where.

November 14, 2011, 15:51		#3
emreg Senior Member Emre G Join Date: May 2011 Location: Turkey Posts: 126 Rep Power: 14	yes. i hav just found the failure. Forcing the .dat file read is missed. i hav to be more careful.. thanks.