CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   how can i initialize after transient work? (

emreg November 14, 2011 13:07

how can i initialize after transient work?
i would like to pass transient work after finishing the steady work.
firstly i made a steady solution in order to get an initialize point.

But now when i chhoose transient, it enforces me to initialize which means that i am losing the previous works :(

how can i solve this? November 14, 2011 14:37

Probably you should be able to continue from the steady state results into transient straight away by choosing transient and then the time step size and the number of time steps along with inner iterations, unless and until you have gone wrong some where.

emreg November 14, 2011 16:51

yes. i hav just found the failure. Forcing the .dat file read is missed. i hav to be more careful..

All times are GMT -4. The time now is 08:12.