CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   run time error (

umar959 November 23, 2011 01:47

run time error
i am using workbench 13 for my project for my BE degree. I have my model in design modeler by points then lines were made from points and then surfaces were made and then single body was made after that meshing was done and when i went to setup for fluent results its was not readable and a message was displayed as run time error can anybody guide me to solve this problem. is there is any problem in modeling or meshing. i will be very thank full to you.

All times are GMT -4. The time now is 16:03.