|
[Sponsors] |
How to setup flux matching between two domains/materials? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2011, 19:43 |
How to setup flux matching between two domains/materials?
|
#1 |
New Member
Ryan Magee
Join Date: Dec 2011
Location: CT
Posts: 1
Rep Power: 0 |
I am attempting to create a 2D model, attached is a file describing my problem i'm attempting to model. I'm using axisymmetric in the center to reduce my mesh size and decrease computing time.The problem I'm encountering is that I do not know how to setup a heat flux matching between the steel pipe domain and my water domain. Any insight into how this might be done would be extremely helpful.
I'm currently using ANSYS Fluent 12.1, im using an academic license. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem setting with chtmultiregionFoam | Antonin | OpenFOAM | 10 | April 24, 2012 09:50 |
Setup for Fluent Flux Reports | Jallen13a | FLUENT | 7 | November 18, 2010 10:32 |
Oscillatory mesh motion setup mesh flux ERROR | jaswi | OpenFOAM Running, Solving & CFD | 5 | August 23, 2007 04:41 |
Question on flux matching | hirokata | FLUENT | 0 | February 23, 2006 01:03 |
[Q] UDS flux matching by using UDF | Jekin | FLUENT | 0 | May 17, 2005 01:35 |